Wavecom FASTRACK M1306B User Manual

Fastrack M1306B User Guide
Using the M1306B Wireless CPU
®
confidential © Page: 35 / 65
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged
without prior written agreement.
WM_PRJ_M13_UGD_001 -003 November 11, 2006
5.8 Main AT Commands for the Wireless CPU
®
The table below lists the main AT commands required for starting the Wireless CPU
®
.
For other AT commands available or further information on the AT commands, refer
to "AT Commands Interface Guide" [7].
Table 8: Main usual AT commands for the Wireless CPU
®
Description AT commands Wireless
CPU
®
response
Comment
OK PIN Code accepted.
+CME
ERROR: 16
Incorrect PIN Code
(with +CMEE = 1 mode) (1*)
Enter PIN Code AT+CPIN=xxxx
(xxxx = PIN code)
+CME
ERROR: 3
PIN code already entered
(with +CMEE = 1 mode) (1*)
+CREG: 0,1 Wireless CPU
®
registered
on
the network.
+CREG: 0,2 Wireless CPU
®
not
registered
on the network,
registration attempt.
Network
registration
checking
AT+CREG?
+CREG: 0,0 Wireless CPU
®
not
registered
on the network, no
registration attempt.
Receiving an
incoming call
ATA OK Answer the call.
OK Communication
established.
+CME
ERROR: 11
PIN code not entered
(with +CMEE = 1 mode).
Initiate a call ATD<phone number>;
(Don’t forget the « ; »
at the end for « voice »
call)
+CME
ERROR: 3
AOC credit exceeded or a
communication is already
established.
Initiate an
emergency call
ATD112;
(Don’t forget the « ; »
at the end for « voice »
call)
OK Communication
established.
Communication
loss
NO
CARRIER

Wavecom FASTRACK M1306B Specifications

General

Brand	Wavecom
Model	FASTRACK M1306B
Category	Computer Hardware
Language	English