To Next Page

To Previous Page

PROBLEM SOLVING

XES SYNERGIX 8850 PRINTER OPERATOR MANUAL 43

Error messages

The error messages shown in the table below may appear on the

message display. Follow the instructions in the table before calling

for service.

Table 3. Error message table

Error Message Problem Solution

CHECK FOLDER

FOLDER COMMUNICATIONS ERROR #17

FINISHER CONFIG TYPE

enabled, but no folder is

installed.

1. Press the On-line/Off-line

key to take the printer off-

line.

2. Reset the value to NONE.

Refer to "Specifying the

finisher configuration

type" in this manual for

instructions.

F2-01 CHECK FOLDER

FOLDER COMMUNICATOINS ERROR #01

FINISHER CONFIG TYPE

enabled, but no folder is

installed.

1. Switch the printer Off.

2. Wait five seconds. Then

switch the printer On.

3. As soon as the Printer

Firmware Version

message is displayed,

press the On-line/Offline

key to take the printer off-

line.

4. Reset the value to NONE.

Refer to "Specifying the

finisher configuration

type" in this manual for

instructions.

Xerox 8850 User Manual

Other manuals for Xerox 8850