PROBLEM SOLVING
44 XES SYNERGIX 8850 PRINTER OPERATOR MANUAL
Problem solving table
The table below lists some conditions that may occur during the
operation of the printer. You may be able to resolve the problems
by following the suggested solutions in the table. For problems
beyond the scope of this table, call for service.
Table 4. Problem-solving table
Condition Causes Suggested Solutions
Portions of the prints are deleted. The media may be damp. Check the condition of the media. If
damp, replace it.
The prints are light overall. The print density may be too light. Use the Printer Menu to adjust the
print density. Refer to "Adjusting
the print density" in this manual.
The media may be too damp. Use a sealed media drawer.
The tracing paper has wrinkles. The media may be too dry. Use a sealed media drawer.
Store the media in a sealed
package or bag.
To Next Page
Loading...
Need help?
General