Unregistered Forms
When a form specified for printing in a form data file (overlay printing) is not present
on the host computer, select whether or not to print the job. If you select Print and the
specified form is not present, only the data is printed.
This setting is added to the print settings menu when there is a print specification from
the host computer.
Resume Job After Print Error
Select Job Resumes Automatically or Resume by User.
When Paper Jam Occurs
Select Resume Job After Jam Clearance or Delete Job.
Print User ID
When printing by a print driver, select whether or not to print the user authentication
information to the paper for the purpose distinguishing the identity of the user. A
maximum of 64 characters can be printed in the user ID information.
Select from one of the following: Off, Top Left, Top Right, Bottom Left, and Bottom
Right.
Note
To use the ID Print feature, the User ID, set by the printer driver, is necessary beforehand.
For the configuration procedure, refer to the online help for the printer driver.
Note
If the user ID information cannot be acquired, the words Unknown User are printed.
Sensing Separator Page
Select Disabled or Enabled.
Banner Sheet
Select whether or not the banner sheets will be used to separate different output jobs.
Select one of the following:
• Off: Do not print banner sheets.
• Start Sheet: Print a banner sheet before a print job.
• End Sheet: Print a banner sheet after a print job.
• Start Sheet & End sheet: Print a banner sheet both before and after a print job.
10-55Xerox
®
D95/D110/D125/D136 Copier/Printer
System Administration Guide
System Settings
To Next Page
Loading...
Need help?
General