Xerox D125 System Administration Guide

Note
Enable the SOAP port and the SNMP port in most cases.
1. Enter the System Administrator mode.
2. Enable either the LPD port or the Port 9100 port as needed. In this example, the LPD
port is enabled.
a) Select System Settings.
b) Select Connectivity & Network Setup.
c) Select Port Settings.
d) Select LPD and then select Change Settings.
e) Select LPD - Port Status and select Change Settings.
f) Select Enabled and then select Save.
g) Select Close repeatedly until the Connectivity & Network Setup screen is displayed.
3. If necessary, set the IP Address.
4. Exit the System Administrator Mode.
5. After the machine is restarted, print the Printer Settings List to confirm that the LPD
port is enabled.
Configuration on the computer
The configuration procedure for the computer is to install the print driver.
NetWare
Preparations
A NetWare server is required when using NetWare network.
Configuration procedure
The machine supports PServer mode for both the NetWare Directory Service and Bindery
Service. PServer mode enables the machine to function as a print server and to capture
print jobs in the print queue to output. The printer created for the machine consumes
one file server license.
Note
The machine does not support Remote Printer (RPrinter) Mode.
Supported interfaces
• 100Base-TX
• 10Base-T
Supported frame types
Xerox
®
D95/D110/D125/D136 Copier/Printer2-2
System Administration Guide
Configuration

Xerox D125 Specifications

General

Brand	Xerox
Model	D125
Category	Printer
Language	English