Xerox D125 System Administration Guide

f) Select Enable and then select Save.
3. If necessary, set the IP Address.
4. Exit the System Administrator mode.
5. After the machine is restarted, print the Printer Settings List to confirm that the SMB
port is enabled.
Note
If using the NetBEUI protocol, select NetBEUI as the protocol used by SMB for the
port configuration by using CentreWare Internet Services.
Configuration on the computer
The configuration procedure for the computer is to install the print driver.
EtherTalk
Preparations
The following item is required when using an EtherTalk network:
• A network environment where EtherTalk can be used.
Configuration procedure
The machine can be connected to computers using an EtherTalk network.
The following is the procedure to connect the machine to the EtherTalk network:
• Configuration on the Machine: Set up EtherTalk on the machine.
• Configuration on the Computer: Install the print driver.
Configuration on the machine (EtherTalk)
This section describes the configuration procedure to connect the machine to EtherTalk
network.
Enable the EtherTalk port
Note
The configuration can also be performed using CentreWare Internet Services. Refer to
Using CentreWare Internet Services.
Note
Enable the SOAP port and the SNMP port in most cases.
1. Enter the System Administrator Mode.
Xerox
®
D95/D110/D125/D136 Copier/Printer2-4
System Administration Guide
Configuration

Xerox D125 Specifications

General

Brand	Xerox
Model	D125
Category	Printer
Language	English