Xerox D125 System Administration Guide

• Connect your card reader to the printer
Configure Network Authentication Settings
1. Configure network authentication.
2. Configure Kerberos server settings.
Enable SmartCard Settings
1. At the printer control panel, press the Machine Status button and touch the Tools
tab.
2. Select Authentication / Security Settings > Authentication > User Details Setup
> Use of SmartCard.
3. Select Change Settings.
4. Select Enabled.
5. Under Jobs Validated by Card, select Copy, Print, or Scan, and select Save.
Configure SmartCard Link Mode Settings
1. At the printer control panel, press the Tools button and touch the Tools tab.
2. Select Authentication / Security Settings > Authentication > User Details Setup
> SmartCard Link Mode.
3. Select Change Settings.
4. Select No Passcode Required, and touch Save.
Setting the SmartCard Certificate Verification Mode
For additional security, you can set the printer to validate a user’s SmartCard against
certificates stored on the printer.
1. At the printer control panel, press the Machine Status button and touch the Tools
tab.
2. Select Authentication / Security Settings > Authentication > User Details Setup
> SmartCard Certificate Verification.
3. Select Change Settings.
4. Select Enabled.
Configuring Certificate Revocation Retrieval Settings
Configure Security Certificate Revocation Retrieval settings as necessary.
Note
The root CA and intermediate CA of the user’s SmartCard certificate must be stored on
the printer. The printer date and time settings must be correct to validate the certificate.
Xerox
®
D95/D110/D125/D136 Copier/Printer5-8
System Administration Guide
Using the Scan Service

Xerox D125 Specifications

General

Brand	Xerox
Model	D125
Category	Printer
Language	English