Service Call Procedures
Phaser 3100 MFP 04/08 1-5
Paper Separator Module (3100 MFP/X only)
Figure 2
1. Set the On/Off switch to Off (position 0).
2. Open the ADF scanner cover.
3. Disassemble the ADF feeder (REP 4).
4. Wipe the elements of the paper separator module with a lint-free cloth soaked with isopropyl
alcohol. Recommended interval: from 2 to 6 months, depending on utilization.
CIS and Document Glass
1. Set the On/Off switch to Off (position 0).
2. Open the scanner cover.
3. Clean the CIS window with a lint-free cloth moistened with isopropyl alcohol or use antistatic
paper used for cleaning optic glass.
Recommended interval: depending on utilization; it is advisable to make a local copy to check if
the window is clean.
Control Panel Keys and Covers
Cleaning the Control Panel Keys
1. Set the On/off switch to Off (position 0).
2. Clean the top of the control panel and the keys with a lint-free cloth moistened with isopropyl
alcohol or a spray-on cleaning product.
3. Leave the product on for a few seconds before wiping it off.
Recommended interval: to be defined depending on utilization.
To Next Page
Loading...
Need help?
General
