General Procedures and Information
6-30 04/08 Phaser 3100 MFP
GP 12 Getting Started and Software Configuration
User Parameters
Refer to the User Guide booklet for a detailed description of parameters available to the user.
Installation Parameters
The installation parameters are used for configuring the machine to the specific requirements of
users.
Each machine is programmed with the factory test configurations. The installer can obtain a print-
ed copy of these parameters (sequence of keys 5 6).
Note: It is recommended to conserve a paper copy of the list of parameters provided at delivery.
Access to these parameters is only authorized for the maintenance and/or installation service
technicians.
The machine comes with software blocks called SOS (Soft Switches) N° 1 to 60. Each block is
made up of 8 bits called bit 1 to 8. Each bit has a value of 0 or 1. Reading the block (from bit 1 to
bit 8) on the display panel is done from right to left. The blinking cursor is always located on the
bit 8 (on the extreme left) when selecting the configuration.
Access to the configuration bytes is available via the initialization screen, via a succession of keys:
The description of the principal configuration parameters for the machine are provided in the List
of Configuration. They can be modified just like any other parameter.
To Next Page
Loading...
Need help?
General
