General Procedures and Information
Phaser 3100 MFP 04/08 6-19
GP 5 Operation
The Xerox 3100MFP range is a Group 3 multi-function machine operating in accordance with the
UIT-T T30 recommendations.
The 3100MFP/X consists of a laser printer, a CIS (Contact Image Sensor) colour ADF scanner, a
colour flatbed scanner, a control panel with an alphanumerical keyboard and a LCD display with
2 lines of 16 characters (refer to the User Guide for a more complete description of the control
panel).
It allows the following operations to be carried out:
• Fax transmission and reception on the switched telephone network using the V34 protocol
(max. 33.6 kbits/s) and the V17 protocol (max. 14.4 kbits/s).
• SMS (Short Message Service) transmission on the switched telephone network using the
V23 protocol (depending on the model).
• Photocopying documents.
• Local printing and scanning for PC via USB connections.
The 3100MFP/S consists of a laser printer, a colour flatbed scanner, a control panel with a numer-
ic keypad and a LCD display with 2 lines of 16 characters (refer to the User Guide for a more com-
plete description of the control panel).
It allows the following operations to be carried out:
• Photocopying documents.
• Local printing and scanning for PC via USB connections.
The electronics for both the 3100MFP/X and the 3100MFP/S are made up of a control panel PWB
and a CPU board. The power supply is provided by the printer.
Before performing any operations on the electronic CPU board, you should:
1. Set the On/Off button to Off (position 0).
2. Unplug all external connectors (phone line connectors, USB connectors master, slave).
3. Unplug the power supply cord.
To Next Page
Loading...
Need help?
General
