General Procedures and Information
Phaser 3100 MFP 04/08 6-53
GP 17 Administrator Functions
Each one of the administrator functions described here is accessible via a specific sequence of
keys. The alphabetic keys are available via the navigation keys and via the keyboard. For
example, to enter a sequence * A (launching scanner calibration):
1. Press the following key
2. Press the following key *.
3. Press to display all the options available until you reach A. Confirm your choice with OK.
Initializing and Erasing Memory
Before you start, set the 8 bit parameter installation configuration 1 to 1.
CAUTION
Undocumented functions are reserved. Do not try and use functions that are not documented in
this section, this may lead to the permanent loss of data.
CAUTION
Undocumented functions are reserved. Do not try and use functions that are not documented in
this section, this may lead to the permanent loss of data.
• Reset all parameters (user, installer or technical) to the default configuration (factory
configuration):
• Erase the directory:
• Erase the logs:
• Erase the printer counters:
• Reinitialize the flash data (erases all):open the printer front door then:
• Erase all. Reset to default configuration (combination of functions 0 and 8):
To Next Page
Need help?
General
