Network Basics
Phaser 7500 Color Printer
User Guide
27
Choosing a Connection Method
Connect the printer via Ethernet or USB. A USB connection is a direct connection and is not used for
networking. An Ethernet connection is used for networking. Hardware and cabling requirements vary
for the different connection methods. Cabling and hardware are generally not included with your
printer and must be purchased separately. This section includes:
• Connecting via Ethernet (Recommended) on page 27
• Connecting via USB on page 28
Connecting via Ethernet (Recommended)
Ethernet can be used for one or more computers. It supports many printers and systems on an Ethernet
network. An Ethernet connection is recommended because it is faster than a USB connection. It also
allows you direct access to CentreWare Internet Services, which enables you to manage, configure, and
monitor network printers from your computer.
Network Connection
Depending on your particular setup, the following hardware and cabling is required for Ethernet.
• If you are connecting to one computer, an Ethernet RJ-45 crossover cable is required.
• If you are connecting to one or more computers with an Ethernet hub, or cable or DSL router, two
or more twisted-pair (category 5/RJ-45) cables are required. (One cable for each device.)
If you are connecting to one or more computers with a hub, connect the computer to the hub with one
cable, and then connect the printer to the hub with the second cable. Connect to any port on the hub
except the uplink port.
See also:
Configuring the Network Address on page 29
Available Printer Drivers on page 35
To Next Page
Loading...
Need help?
General