Copying
108 Xerox
®
WorkCentre
®
3655/3655i Multifunction Printer
User Guide
Selecting Book Copying
When copying a book, magazine, or other bound document, you can copy either the left or right page
onto a single sheet of paper. You can copy both the left and right pages onto two sheets of paper, or as
a single image on one sheet of paper.
Note: You must use the document glass to make copies from books, magazines, or other bound
documents. Do not place bound originals in the document feeder.
To set up book copying:
1. Press the Services Home button, then touch Copy.
2. Touch the Layout Adjustment tab, then touch Book Copying.
3. On the Book Copying screen, select an option:
− Off copies both pages of an open book as one image on a single sheet of paper.
− Both Pages copies the left and the right pages of an open book onto two sheets of paper. If
Binding Edge Erase is required, touch the arrows to erase up to 50.8 mm (2 in.).
− Left Page Only copies only the left page of an open book on a single sheet of paper. If Binding
Edge Erase is required, touch the arrows to erase up to 25.4 mm (1 in.).
− Right Page Only to copy only the right page of an open book on a single sheet of paper. If
Binding Edge Erase is required, touch the arrows to erase up to 25.4 mm (1 in.)
4. Touch OK.
Shifting the Image
You can change the placement of an image on the copy page. This is useful if the image is smaller than
the page size. Originals must be positioned as follows for image shift to work correctly:
• Document Feeder: Position originals face up, long edge entering the feeder first.
• Document Glass: Position originals face down, in the back-left corner of the document glass, long
edge to the left.
To change the placement of the image:
1. Press the Services Home button, then touch Copy.
2. Touch the Layout Adjustment tab, then touch Image Shift.
3. On the Image Shift screen, select an option:
− Auto Center centers the image on the page.
− Margin Shift allows you to specify the position of the image. To specify the amount of shift for
Side 1, touch the Up/Down and Left/Right arrows. To specify the amount of shift for Side 2,
touch the Up/Down and Left/Right arrows, or select Mirror Side 1.
Note: You can use preset values that were previously saved by the system administrator. Touch
Presets in the lower left corner of the screen, and select a preset from the drop-down menu.
4. Touch OK.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
