ZC702 and ZVIK Getting Started Guide www.xilinx.com 11
UG926 (v3.0.1) February 12, 2013
Key Features of the ZC702 Evaluation Board
°
Zynq-7000 processor reference clock—Fixed (33.33 MHz) LVCMOS oscillator
(single-ended)
• Ethernet PHY RGMII interface with RJ-45 connector
• 10/100/1,000 tri-speed Ethernet PHY
•USB-to-UART bridge
•HDMI codec
•I2C bus
• I2C bus multiplexed to:
°
Si570 user clock
°
ADV7511 HDMI codec
°
M24C08 EEPROM (1 KB)
°
1-to-16 TCA6416APWR port expander
°
RTC-8564JE real-time clock
°
FMC1 LPC I/O expansion connector
°
FMC2 LPC I/O expansion connector
°
PMBUS data/clock
•Status LEDs:
°
Ethernet status
°
Power good
°
FPGA INIT
°
FPGA DONE
•User I/O:
°
Eight user LEDs
°
Two user pushbuttons
°
Two user switches (2-position DIP switches)
• CPU reset pushbutton
• Two VITA 57.1 FMC LPC connectors
• Power on/off slide switch
• Power management with PMBus voltage and current monitoring through TI power
controllers
• XADC header with access to dual 12-bit 1 MSPS XADC port
• (SW1 – POR_B) boot configuration options: