ZC702 and ZVIK Getting Started Guide www.xilinx.com 39
UG926 (v3.0.1) February 12, 2013
Running the UART Menu-Based Demonstration Application
9. The application can be restarted by typing the following at the Linux command prompt:
zynq> cd /mnt
zynq> ./run_sobel.sh –qt
Running the UART Menu-Based Demonstration
Application
A command line based Linux application demonstration is also provided with the package.
This application presents the user with a command line menu-based UI to exercise different
modes of the video demonstration.
To run the menu-based UI application demonstration, the Qt-based GUI application which
was started (as explained in Running the Qt-Based GUI Application Demonstration, page 34)
needs to be quit as per step 8, page 38.
The following steps explain how to start the UART menu-based application demonstration
and exercise different application video use cases.
1. Go to the UART terminal started on your host PC as explained in step 2 from Running the
Qt-Based GUI Application Demonstration, page 34.
2. Type these commands at the Linux command prompt into the host PC based terminal:
zynq> cd /mnt
zynq> ./run_sobel.sh –cmd
The menu-based video application demonstration starts as shown in Figure 3-9.
To Next Page
Loading...
