EasyManuals Logo
Home>Yaesu>Transceiver>FTDX101MP

Yaesu FTDX101MP User Manual

Yaesu FTDX101MP
129 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
16
Rear Panel
ANT 1 ANT 2
EXT SPKR KEY
ACC TUNER
PTT
METER
GND
LINEAR
+13.8V
REM
EXT ALC RS-232C
A B
Cooling FAN
ANT 1, 2, 3/RX
Connect the main antenna(s) here, using type-M
(PL-259) connectors and coaxial feed lines. The
internal antenna tuner affects only the antenna(s)
connected here, and only during transmission.
EXT SPKR
This 3.5-mm, 2-contact, jacks provide audio output
for external loudspeakers. The impedances at the
jacks are 4 - 8 Ohms, and the volume varies ac-
cording to the setting of the front panel [AF] knob.
Inserting plugs into the jacks alters the inter-
nal loudspeaker conguration.
Depending on the plugs connected to the jacks, the
conguration of the internal and external speakers
varies.
A B
Internal
Speaker
Connect to
A only
MAIN and
SUB audio
- -
Connect to
B only
- MAIN audio SUB audio
Connect to
both A and B
SUB audio MAIN audio -
SIGNAL
GND
KEY
This 1/4-inch 3-contact jack accepts a CW key or
keyer paddle. A two-contact plug cannot be used
in this jack. Key-up voltage is +5.0 V DC, and key-
down current is 3 mA.
KEY
NC
GND
When connecting a single straight key
DOT
DASH
COMMON
When connecting an electronic keyer paddle
AF-OUT
This 3.5-mm, 3-contact jack provides dual-channel
low-level receiver output, for recording or external
amplication.
The front panel [AF] knobs do not affect
the signals at this jack (300 mVp-p at 10
k-ohms).
AUDIO (MAIN)
AUDIO (SUB)
GND
REM
By plugging the FH-2 Remote Control Keypad into
this jack, direct access to the FTDX101 CPU is pro-
vided for control functions of the contest memory
keying, and also frequency and function control.
RTTY/DATA
This 6-pin input/output jack accepts AFSK input
from a Terminal Node Controller (TNC); it also pro-
vides fixed level receiver audio output, and FSK
keying line.
DATA IN
PTTSHIFT
GND
DATA OUTSQL
METER
This 3.5-mm jack is to connect an external meter.
The meter display is output as an analog voltage (0
V to about 3 V).
Insert appropriate resistors in series according to
the meter you use.
SIGNAL (MAIN)
SIGNAL (SUB)
GND

Table of Contents

Other manuals for Yaesu FTDX101MP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yaesu FTDX101MP and is the answer not in the manual?

Yaesu FTDX101MP Specifications

General IconGeneral
BrandYaesu
ModelFTDX101MP
CategoryTransceiver
LanguageEnglish

Related product manuals