Yaesu FTDX101MP User Manual

62
• Checking the CW Memory Contents
1. Be sure that Break-in is still turned “OFF” by
the [BK-IN] key.
2. Press the [MONI] key to enable the CW mon-
itor.
When using FH-2, go to step 5.
3. Press the [FUNC] key.
4. Touch [REC/PLAY] .
5. Touch [1] - [5] on the display or press the
FH-2 [1] - [5] key, whichever memory was just
recorded. The message will be played and
heard in the sidetone monitor, but no RF en-
ergy will be transmitted.
● The “MSG” and “PLAY” icon will appear in
the display.
● To adjust the volume level during playback,
press and hold the [MONI] key then rotate
the [MULTI] knob.
• On-The-Air CW Message Playback
1. Press the [BK-IN] key to enable transmission.
When using FH-2, go to step 4.
2. Press the [FUNC] key.
3. Touch [REC/PLAY] .
4. Touch [1] - [5] on the display or press the
FH-2 [1] - [5] key, to transmit the recorded
CW Memory Register message. The pro-
grammed message will be transmitted on the
air.
● During a transmission, the same key may
be pressed again to immediately end the
transmission.
Transmitting in the Beacon Mode
In “Beacon” mode, any programmed mes-
sage, (either via Paddle, or via “Text” input
method) may be repeatedly transmitted.
The time delay between message repeats
may be set from 1 to 60 seconds, in one
second steps, via Menu item “REPEAT IN-
TERVAL”.
To transmit the message:
1. Touch and hold [1] - [5] on the display
or press and hold the FH-2 [1] - [5] key.
Repetitive transmission of the Beacon
message will begin.
2. Press the same key again to cancel the
Beacon Mode.

Yaesu FTDX101MP Specifications

General

Brand	Yaesu
Model	FTDX101MP
Category	Transceiver
Language	English