Yaesu FTDX101MP User Manual

72
Memory Operation
V
u
M
• Memory Storage
1. Set the frequency, mode, and status, as de-
sired.
2. Press the [V
u
M] key.
The memory channel list will be displayed.
3. From the channel list, touch and select the
desired memory channel
Alternately, the memory channel may be se-
lected by rotating the [MULTI] knob.
4. Press and hold the [V
u
M] key to store the
frequency and other data into the selected
memory channel.
● This method may also be used to overwrite
the contents previously stored to a memory
channel.
5. Press the [V
u
M] key, the memory is stored
and the screen returns normal.
The information saved in the memory may
be lost due to incorrect operation, static
electricity or electrical noise. Data may also
be lost due to component failures and re-
pairs. Make sure to write down the informa-
tion registered in the memories on a piece of
paper or by using a SD card (page 81).
• Erasing Memory Channel Data
The contents written to the memory channel may
be erased.
1. Press the [V
u
M] key.
The memory channel list will be displayed.
2. From the channel list, touch and select the
memory channel to be erased.
Alternately, the memory channel may be se-
lected by rotating the [MULTI] knob.
3. Touch [ERASE] to clear the contents of the
selected memory channel.
4. Press the [V
u
M] key to erase the contents of
the selected memory channel.
If you make a mistake and wish to restore a
memories contents, touch [RESTORE].
Memory channels “M-01” (and “5-01”
through “5-10”: U.S. version) cannot be
erased.

Yaesu FTDX101MP Specifications

General

Brand	Yaesu
Model	FTDX101MP
Category	Transceiver
Language	English