Operation
56
turns smoothly and that it completely re-
turns to the fully closed position.
Look for loose or damaged connections of
the throttle and shift cables.
Remote control models:
Turn the steering wheel full-right and full-
left. Make sure operation is smooth and
unrestricted throughout the whole range
with no binding or excessive free play.
Operate the throttle levers several times to
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.
Look for loose or damaged connections of
the throttle and shift cables.
EMU36483
Engine shut-off cord (lanyard)
Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
EMU40993
Engine oil
1. Place the outboard motor in a vertical
position (not tilted). NOTICE: If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01861]
2. Remove the oil dipstick and wipe it
clean.
1. Cord
2. Clip
3. Engine shut-off switch
1. Cord
2. Clip
3. Engine shut-off switch
6C1-9-3B-1E0.book 56 ページ ２０１２年１１月１９日 月曜日 午前１０時３５分
To Next Page
Loading...
Need help?
General
