Operation
63
fuel valve may also be equipped on the
boat. Open the fuel valve.
Check the boat’s manual for the position of
the fuel valve.
10. Squeeze the primer pump, with the ar-
row pointing up, until you feel it become
firm. During engine operation, place the
tank horizontally, otherwise fuel cannot
be drawn from the fuel tank.
EMU27494
Starting engine
EWM01600
Before starting the engine, make sure
that the boat is tightly moored and that
you can steer clear of any obstructions.
Be sure there are no swimmers in the wa-
ter near you.
EMU27595
Electric start / prime start models
EWM01840
Failure to attached engine shut-off cord
could result in a runaway boat if opera-
tor is ejected. Attach the engine shut-
off cord to a secure place on your cloth-
ing, or your arm or leg while operating.
Do not attach the cord to clothing that
could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
1. Place the gear shift lever in neutral.
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
1. Arrow
2. Primer pump
6C1-9-3B-1E0.book 63 ページ ２０１２年１１月１９日 月曜日 午前１０時３５分
To Next Page
Loading...
Need help?
General
