EasyManuals Logo
Home>Yamaha>Motorcycle>YZ250F(E)

Yamaha YZ250F(E) User Manual

Yamaha YZ250F(E)
356 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #149 background imageLoading...
Page #149 background image
REAR BRAKE
4-25
EAS1SM1149
INTRODUCTION
EWA14300
WARNING
If you need to disassemble the disc brake
components, observe the following precau-
tions.
Never disassemble the brake components
unless absolutely necessary.
If there is any problem with connections
on the hydraulic brake system, perform
the following jobs.
Disassemble the brake system, drain the
brake fluid, and clean it. After that, add a
suitable amount of brake fluid. Then, bleed
it after reassembly.
Use only brake fluid for washing internal
brake components.
Use new brake fluid for cleaning the brake
components.
Immediately wipe off the spilled brake fluid
to avoid damage to painted surfaces or
plastic parts.
Handle brake fluid with special care not to
let it enter your eyes so that you may not
lost your eyesight.
FIRST AID FOR BRAKE FLUID ENTERING
THE EYES:
Flush with water for 15 minutes and get
immediate medical attention.
EAS1SM1150
CHECKING THE REAR BRAKE DISC
1. Remove:
Rear wheel
Refer to “REAR WHEEL” on page 4-7.
2. Check:
Brake disc
Damage/galling Replace.
3. Measure:
Brake disc thickness
Measure the brake disc thickness at a few
different locations.
Out of specification Replace.
Refer to “CHECKING THE FRONT BRAKE
DISC” on page 4-15.
4. Measure:
Brake disc deflection
Out of specification Correct the brake disc
deflection or replace the brake disc.
5. Adjust:
Brake disc deflection
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the brake disc.
b. Turn the mounted position of the brake disc
by one bolt hole.
c. Install the brake disc.
TIP
Tighten the brake disc bolts in stages and in a
crisscross pattern.
d. Measure the brake disc deflection.
e. If out of specification, repeat the adjustment
steps until the brake disc deflection is within
specification.
f. If the brake disc deflection cannot be
brought within specification, replace the
brake disc.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
6. Install:
Rear wheel
Refer to “REAR WHEEL” on page 4-7.
Brake disc thickness limit
3.5 mm (0.14 in)
Brake disc deflection limit
0.15 mm (0.0059 in)
Brake disc bolt
14 Nm (1.4 m·kgf, 10 ft·lbf)
LOCTITE®
T
R
.
.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha YZ250F(E) and is the answer not in the manual?

Yamaha YZ250F(E) Specifications

General IconGeneral
BrandYamaha
ModelYZ250F(E)
CategoryMotorcycle
LanguageEnglish

Related product manuals