| Call Features | 20
5.
Do the following to place a SIP call on the phone.
a) Select Conf.
b) Enter the desired number.
c)
Select Send or .
6.
Repeat the step 5 to invite more parties (up to 4 parties).
7.
Select Conf.
Network Conference
If your system administrator has set a network conference feature on your phone, you can initiate a conference with
two or more contacts.
Setting Up a Network Conference
You can set up a network conference with two or more contacts.
1.
Place a call to the first party.
2.
Select Conference.
The active call is placed on hold.
3.
Dial the second party’s number.
4.
When the second party answers the call, select Conf. to add the second party to the conference.
5.
Select Conf. to place a new call.
The conference call is placed on hold.
6.
Enter the number of the new party, and then press the OK key.
7.
When the new party answers the call, select Conf to add the new party to the conference.
8.
Repeat steps 5 to 7 until you add all parties.
Note: The procedures for setting up a network conference call on specific servers may be different.
Contact your system administrator for more information.
Inviting another Party into an Active Conference Call
Any party in the conference call can invite other party into an active conference call.
1.
Select Conf. or Hold > New Call.
2.
Enter the desired number and dial out.
3.
When the new party answers the call, select Conf..
The new party is joined the conference call.
Holding/Resuming a Conference Call
Any party in the conference call can place himself/herself on hold, but other parties can continue the conference call
normally.
Note: The conference call will only be held when all parties in the conference call place themselves on hold.
1.
Select Hold.
2.
Select Resume to resume the held conference call.
Ending a Conference Call
You can end the current conference call at any time.
Press or End Call.
To Next Page
Loading...
Need help?
General
