| Maintaining Your Phone | 40
Restarting the Base Station
The improper operation may cause malfunction. If a malfunction occurs, your system administrator may ask you to
restart the base station to refresh the settings.
1.
Go to Menu > Settings > Advanced Settings (default PIN: 0000) > Reboot Config > Base Reboot.
A message prompts whether to reboot the base.
2.
Confirm the action.
After the above steps, the registration LED and network status LED on the base station go out simultaneously. After a
period of time, the LED indicators will glow green again when the base station restarts successfully.
Resetting the Base Station
Your system administrator may ask you to reset your phone to factory after you have tried all troubleshooting
suggestions but still do not solve the problem.
Except the phone registrations, the phone will reset all settings to the factory defaults after the resetting. Check with
your system administrator if the personalized settings are kept before resetting your phone to factory.
1.
Go to Menu > Settings > Advanced Settings (default PIN: 0000) > Reboot Config > Reset Base Settings.
A message prompts whether to reset the base.
2.
Confirm the action.
All individual settings of the base station will be reset to factory defaults. The power LED indicator and network LED
indicator on the base station slowly flash in sequence during the resetting. LEDs on the base station glow green after
startup.
Important: Base station reset may take a few minutes. Do not power off until the base station starts up
successfully.
Resetting the Handset
You can reset individual settings that you have configured on the handset.
Except the settings of directory, call history, voice mail, and the handset registration, the handset will reset all
customized settings to factory after the resetting.
1.
Go to Menu > Settings > Advanced Settings (default PIN: 0000) > Handset Reset.
The phone prompts you whether to reset the handset.
2.
Confirm the action.
Triggering the Auto Provisioning
Your system administrator may ask you to update your phone configurations. You can trigger the auto provisioning
using the wizard.
1.
Go to Menu > Settings > Advanced Settings (default PIN: 0000) > Auto Provision.
2.
Enter the user name, select OK.
3.
Enter the password, select OK.
The phone prompts whether to update immediately.
4.
Confirm the action.
To Next Page
Loading...
Need help?
General
