10
YORK INTERNATIONAL
Rotating Parts
Fan guards must be fitted at all times and not removed
unless the power supply has been isolated. If ductwork
is to be fitted, requiring the wire fan guards to be re-
moved, alternative safety measures must be taken to
protect against the risk of injury from rotating fans.
Sharp Edges
The fins on the air-cooled condenser coils have sharp
metal edges. Reasonable care should be taken when
working in contact with the coils to avoid the risk of
minor abrasions and lacerations. The use of gloves is
recommended.
Refrigerants and Oils
Refrigerants and oils used in the unit are generally non-
toxic, non-flammable and non-corrosive, and pose no
special safety hazards. Use of gloves and safety glasses
are, however, recommended when working on the unit.
The build-up of refrigerant vapor, from a leak for ex-
ample, does pose a risk of asphyxiation in confined or
enclosed spaces, and attention should be given to good
ventilation. For more comprehensive information on
safety precautions for use of refrigerants and oils, refer
to the Materials Safety Data tables provided on pages
11 through 13.
High Temperature and Pressure Cleaning
High temperature and pressure cleaning methods (e.g.
steam cleaning) should not be used on any part of the
pressure system as this may cause operation of the pres-
sure relief device(s). Detergents and solvents which may
cause corrosion should also be avoided.
EMERGENCY SHUTDOWN
In case of emergency, the electrical option panel is fit-
ted with an emergency stop switch CB3 (Circuit Breaker
3), located in the bottom right of the Microprocessor
Panel. Separate Circuit Breakers, CB1 (System 1) and
CB2 (System 2) can also be used to stop the respective
system in an emergency. When operated, each removes
the electrical supply from the control system, thus shut-
ting down the unit.
General Chiller Information & Safety
To Next Page
Loading...
Need help?
General