YORK INTERNATIONAL
2
FORM 150.62-NM7 (103)
YORK INTERNATIONAL
2
GEN ER AL SAFETY GUIDELINES
This equipment is a relatively complicated apparatus. During in stal la tion, op er a tion,
main te nance or service, individuals may be exposed to cer tain com po nents or
con di tions in clud ing, but not limited to: refrigerants, oils, ma te ri als under pres sure,
ro tat ing com po nents, and both high and low voltage. Each of these items has the
potential, if misused or handled improperly, to cause bodily injury or death. It is the
obligation and responsibility of operating/service per son nel to identify and rec og nize
these inherent hazards, protect themselves, and pro ceed safely in com plet ing their
tasks. Failure to comply with any of these re quire ments could result in serious
damage to the equipment and the prop er ty in which it is situated, as well as severe
personal injury or death to themselves and people at the site.
This document is intended for use by owner-authorized operating/service per son nel.
It is ex pect ed that this in di vid u al possesses independent training that will en able
them to per form their assigned tasks properly and safely. It is essential that, prior
to performing any task on this equipment, this individual shall have read and un-
derstood this document and any referenced materials. This individual shall also be
familiar with and comply with all applicable governmental standards and reg u la tions
pertaining to the task in question.
SAFETY SYMBOLS
The following symbols are used in this document to alert the reader to areas of
potential hazard:
DANGER indicates an im mi nent ly hazardous sit u a tion which, if not avoid ed,
will re sult in death or se ri ous injury.
WARNING indicates a po ten tial ly haz ard ous sit u a tion which, if not avoid ed,
could re sult in death or se ri ous injury.
IMPORTANT!
READ BEFORE PRO CEED ING!
To Next Page
Loading...
Need help?
General
