1717
YHVP-ECM
YHVP-ECM Serie
YHVP-ECM MODELS WITHOUT ELECTRIC HEATER
All versions are available without valves, with 2 way valve or with 3 way valve tted in the unit.
There are four sizes available in the following versions:
YHVP-ECM without infra-red remote control and without valve
YHVP-ECM-2V without infra-red remote control with tted 2 way valve
YHVP-ECM-3V without infra-red remote control with tted 3 way valve
----------------------------------------------------------------------------------------
YHVP-ECM-T with infra-red remote control and without valve
YHVP-ECM-T-2V with infra-red remote control with tted 2 way valve
YHVP-ECM-T-3V with infra-red remote control with tted 3 way valve
------------------------------------------------------------------------------------
YHVP-ECM-MB with MB electronic board and without valve
YHVP-ECM-MB-2V with MB electronic board with tted 2 way valve
YHVP-ECM-MB-3V with MB electronic board with tted 3 way valve
CONSTRUCTIONAL FEATURES OF THE MAIN COMPONENTS
Casing
Made of auto-extinguishing ABS UL94 HB plastic with high specications and great resistance to aging.
The diffusion ap is adjusted manually in YHVP-ECM version, with remote control in YHVP-ECM-T version and with JTM-B
control in YHVP-ECM-MB version.
Air Filter
Washable-regenerable synthetic lter, readily accessible.
Fan Assembly
Made of plastic tangential fan.
Electronic motor
Electronic motor with three phase permanent magnet brushless electronic motor that is controlled with reconstructed current
according to a BLAC sinusoidal wave.
The inverter board that controls the motor operation is powered by 230 Volt, single-phase and, with a switching system, it
generates a three-phase frequency modulated, wave form power supply.
The electric power supply required for the machine is therefore single-phase with voltage of 230-240V and frequency of 50-60Hz.
Heat exchange coil
It is manufactured from drawn copper tube and the aluminium ns are mechanically bonded onto the tube by an expansion
process. The coil has two 1/2 inch BSP internal connections and 1/8 inch BSP air vent and drain.
The heat exchanger is not suitable for use in corrosive atmosphere or in environments where aluminium may be subject to
corrosion.
The connections are on the left side facing the unit only.
Condensate Collection Tray
Made from polypropylene; the outside diameter of the condensate discharge pipe is 16mm.
Installation template
A cardboard installation template is supplied with every unit to help the mounting on the wall.
Versions and Main components
To Next Page
Loading...
Need help?
General
