Zebra ZM400 User Manual

77
Routine Maintenance
Cleaning Schedule and Procedures
2/26/10 ZM400 User Guide for UPS P1016807-001 Rev. A
Cleaning Schedule and Procedures
Specific cleaning procedures are provided on the following pages. Table 12 shows the
recommended cleaning schedule. These intervals are intended as guidelines only. You may
have to clean more often, depending upon your application and media.
.
Clean the Exterior
You may clean the exterior surfaces of the printer with a lint-free cloth and a small amount of a
mild detergent, if necessary. Do not use harsh or abrasive cleaning agents or solvents.
Important • Zebra is not responsible for damage caused by the use of cleaning fluids on this
printer.
Table 12 • Recommended Cleaning Schedule
Area Method Interval
Printhead Solvent* After every roll of media (or 500 feet of fanfold
media).
Platen roller Solvent*
Media sensors Air blow
Media path Solvent*
Tear-off bar Solvent* Once a month.
Take-label sensor Air blow Once every six months.
* Zebra recommends using Preventive Maintenance Kit (part number 47362). In place of this kit, you may use a clean swab
dipped in a solution of isopropyl alcohol (minimum 90%) and deionized water (maximum 10%).

Zebra ZM400 Specifications