©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following document are registered
trademarks of Zortrax and are subject to legal protection.
34
Starting and Removing a Print
Once your model has been prepared for 3D printing in Z-SUITE, save it on your computer’s hard drive,
and then on an SD card. Next, insert the card into the card reader in the printer.
Open the “Models” tab in the main menu to choose the model you want to print.
Turn the knob to select the model. Press the knob to start the printing process.
At this point the printer will start to heat up the extruder.
WARNING! The extruder will be hot. Don’t touch it. Wear safety gloves.
The printing process will start automatically.
Remove the print very carefully because there are some elements of the printer that can get damaged
during the process. The following instructions show the correct procedure of removing the print from
the platform.
1. Turn o the printer and unplug the power cable.
WARNING! WAIT 30 MINUTES UNTIL THE PLATFORM AND THE PRINT COOL DOWN.
To Next Page
Loading...
Need help?
General
