Zte ZXHN H2640 User Manual

ZXHN H2640 Maintenance Management Guide(TIM)
4-26
SJ-20200714160642-002 | 2020-07-27(R1.0)
Parameter
Description
Click Off to disable the function.
Name
Name of the Service Control item.
The name must be specified.
Target
Specify to discard or permit the data packages.
Ingress
Specify the data stream inbound direction, and this parameter must
be specified.
 If the Ingress is WAN_All, all the WAN connection can access
ZXHN H2640.
 If the Ingress is LAN, the LAN side can access ZXHN H2640.
 If the Ingress is a WAN or Route_3G connection, the connection
selected can access ZXHN H2640.
Prefix
IPv6 address prefix.
Service Type
Type Specify the service that is permitted or denied to access.
6. Click Apply button to apply the changes.
Configuring the Remote Service Port Control-IPv4
7. Click Remote Service Port Control - IPv4 to open Remote Service Port Control -
IPv4 page, see Figure 4-22.
Figure 4-22 Remote Service Port Control - IPv4 Page
Table 4-13 lists the remote service port control - IPv4 parameters.
Table 4-13 Parameter Descriptions for the Remote Service Port Control - IPv4
Parameter
Description
HTTPS
The remote service port control of HTTPS.
8. Click Apply button to apply the changes.
4.4.4 Configure the ALG
The section describes how to configure ALG. ALG provides the relevant parameters of
security configuration function.
Abstract

Zte ZXHN H2640 Specifications

General

Brand	Zte
Model	ZXHN H2640
Category	Gateway
Language	English