Functions in the Options menu 43
Functions in the Options
menu
What this chapter contains
The chapter describes functions in the Options menu.
Options menu
In the Options menu, you can control the settings
related to the Home view.
The Options menu has the following sub-menus:
• Reference: Set the reference value by
using
and . The changes take place
when you save them with a key press
. See Setting the reference (page
44).
• Direction change: Change the direction of the motor’s rotation in local control
mode.
• Select drive: Enable or disable the panel bus. If enabled, view the status of
drives in the panel bus and select which drive to control with the control panel.
See chapter Control of multiple drives (page 47).
• Edit Home view: Edit the contents of the Home view. See Editing the
contents of the Home view (page 44).
• Active faults: View an active faults. See chapter Fault tracing (page 51).
• Active warnings: View an active warnings. See chapter Fault tracing (page
51).
To Next Page
Loading...
Need help?
General
