ABB ACS150 User Manual

Control panel
51
Output mode
In the Output mode, you can:
• monitor actual values of up to three group 01 OPERATING DATA signals, one
signal at a time
• start, stop, change direction, switch between local and remote control and set the
frequency reference.
You get to the Output mode by pressing the key until the display shows text
OUTPUT at the bottom.
The display shows the value of one group 01
OPERATING DATA signal. The unit is shown on the
right. Page 54 tells how to select up to three signals to
be monitored in the Output mode. The table below
shows how to view them one at a time.
How to browse the monitored signals
Step Action Display
1. If more than one signals have been selected to be monitored (see page
54), you can browse them in the Output mode.
To browse the signals forward, press key repeatedly. To browse
them backward, press key repeatedly.
REM Hz
OUTPUT FWD
491
.
REM Hz
OUTPUT FWD
491
.
A
REM
OUTPUT FWD
05
.
REM %
OUTPUT FWD
107
.

ABB ACS150 Specifications

General

Brand	ABB
Model	ACS150
Category	Controller
Language	English