Control panel
53
Parameter modes
There are two parameter modes: Short Parameter mode and Long Parameter mode.
Both function identically, except that the Short Parameter mode shows only the
minimum number of parameters typically required to set up the drive (see section
Parameters in the Short Parameter mode on page 66). The Long Parameter mode
shows all user parameters including those shown in the Short Parameter mode.
In the Parameter modes, you can:
• view and change parameter values
• start, stop, change direction, switch between local and remote control and set the
frequency reference.
How to select a parameter and change its value
Step Action Display
1. Go to the Main menu by pressing if you are in the Output mode,
otherwise by pressing repeatedly until you see MENU at the bottom.
2. If the panel is not in the desired Parameter mode (“PAr S”/“PAr L” not
visible), press key or until you see “PAr S” (Short Parameter
mode) or “PAr L” (Long Parameter mode), as appropriate.
3. Short Parameter mode (PAr S):
• Press . The display shows one of the parameters of the Short
Parameter mode. Letter s in the top right corner indicates that you are
browsing parameters in the Short Parameter mode.
Long Parameter mode (PAr L):
• Press . The display shows the number of one of the parameter
groups in the Long Parameter mode.
• Use keys and to find the desired parameter group.
• Press . The display shows one of the parameters in the selected
group.
4. Use keys and to find the desired parameter.
5. Press and hold for about two seconds until the display shows the
value of the parameter with underneath indicating that changing of the
value is now possible.
Note: When is visible, pressing keys and
simultaneously changes the displayed value to the default value of the
parameter.
LOC
MENU FWD
rEF
LOC
MENU FWD
PAr S
LOC
MENU FWD
PAr L
LOC s
PAR FWD
1202
LOC
PAR FWD
-01-
LOC
PAR FWD
-12-
LOC
PAR FWD
1202
LOC
PAR FWD
1203
SET
SET
LOC
Hz
PAR SET FWD
100
.
To Next Page
Loading...
Need help?
General
