44 Operation
While the motor is accelerating, the run status indication on the display blinks.
When the motor speed has reached the setpoint, the run status indication lights
up permanently.
Stopping the drive
This section describes how to stop the drive using the local operator panel of the
drive. If the drive is remotely-controlled, follow the established shutdown
procedures.
• For details on using the local control panel see ACS-AP-X assistant control panels
user’s manual
(3AUA0000085685 [English])
1. Enable the local control mode of the control panel by pressing the Loc/Rem key
(1).
2. Press the Stop key (2).
The motor stops according to the preset stop function and the drive stops
modulating. When the motor has reached zero speed, the drive is in state
Stopped and the display shows .
DANGER
Hazardous voltages!
The ACS580MV is not de-energized in the state Stopped. Before doors are opened
/ removed or work is begun on the drive, the system must first be de-energized
(see
Maintenance
,
Shutting down the drive for maintenance
in
ACS580MV
hardware manual
(2UBB004520 [English]).
To Next Page
Loading...
Need help?
General
