ABB COM600 Station Automation Series User Manual

DescriptionValue or Value range/ DefaultProperty/ Para-
meter
Specifies the multiplier for current SI unit.Default: DekaMultiplier
Specifies the number of decimals shown
in HSI. (0 to 9)
Default: 0Phase Number of
Decimals
Scale to be used with this type.Default: NoneScale
SI unit for measurement as described in
IEC61850
Default: DimensionlessUnit
Limit Value Super-
vision
Maximum value for measurementMax
Minimum value for measurementMin
Table 3.4.8.7-2 Additional configurable properties for Sub-Type Limit Check
DescriptionValue or Value range/ DefaultProperty/ Para-
meter
MVSubTypeDescriptionLimit CheckSub-Type
Limit Value Super-
vision
High limit for measurement. Event is cre-
ated when value crosses the limit.
Default: 0High
High-high limit for measurement. Event is
created when value crosses the limit.
Default: 0High-High
Low limit for measurement. Event is cre-
ated when value crosses the limit.
Default: 0Low
Low-low limit for measurement. Event is
created when value crosses the limit.
Default: 0Low-Low
Delta (DEL)3.4.8.8.
Table 3.4.8.8-1 Configurable DEL properties for OPC client
DescriptionValue or Value range/ DefaultProperty/ Para-
meter
Basic
Common data class according to IEC
61850.
DELCommon Data
Class
Addresses
Phase AB Index-1 to 65535
Default: -1
Phase AB Index
34
1MRS756566
COM600 Station Automation Series
DNP 3.0
LAN/WAN Master
(OPC) 3.2
User's Guide

ABB COM600 Station Automation Series Specifications

General

Brand	ABB
Model	COM600 Station Automation Series
Category	Controller
Language	English