AERMEC HMI-1 User Manual

8
2.3 BACKLIGHTING
Among the general setting page, when "Back light" is set to "Energy save", the display panel will light o when there is no operation in 5 minutes. However, it will light on again
by touching any valid area. When "Back light" is set to "Lighted", the display panel will be kept lighting on. It is suggested to set it to "Energy save" so as to extend its service life.
3 BASIC FUNCTIONS
3.1 SWITCHING THE UNIT ON AND OFF ON/OFF
16:41
2017-05-04 Fri.
Function Parameter View Commission General
To switch the unit on or o, press the ag shown in the gure; once this is done, the system will ask for conrmation of the switching on or o through another window where
the on/o command can be conrmed or cancelled.
 Note:
1. Once the voltage supply has been connected for the rst start-up, this function will be set on “O”;
2. ON/OFF operation will be memorized by setting "On/O Memory" to be "On" at the General menu.
That is, in case of power failure the unit will resume running upon power recovery. Once "On/O Memory" is set to be "O", in case of power failure the unit will keep "O"
upon power recovery.
3.2 SELECTING A MENU
16:41
2017-05-04 Fri.
Function Parameter View Commission General
To enter one of the menus available to the user; click on the corresponding icon; on entering them, each menu (depending on the one selected) will allow you to browse the
various pages or enter other sub-menus linked to specic functions.
Press the HOME icon to return to the main page.

AERMEC HMI-1 Specifications

General

Brand	AERMEC
Model	HMI-1
Category	Controller
Language	English