Setting Up the Oscilloscope
To turn on the oscilloscope
1-28
To turn on the oscilloscope
1 Depress the power switch in the lower left-hand corner of the
oscilloscope front panel.
Figure 1-22
Turning on the Oscilloscope
After a short initialization period, the oscilloscope display appears. The
oscilloscope is ready to use.
2 Hook up all cables and accessories before applying power. You can
connect and disconnect probes and the keyboard while the oscilloscope
is turned on.
Screen Saver
The oscilloscope display has a screen saver that turns off the backlight when there
has been no front panel or graphical interface activity for a pre-determined period.
The default time is 8 hours and is configurable through the Display Setup dialog in
the graphical interface. You can turn the display on by moving the mouse, typing on
the keyboard, pressing a front panel key, or turning a front panel knob.
To Next Page
Loading...
Need help?
General
