Agilent Technologies 54831A User Manual

Using the Oscilloscope
To start and stop waveform acquisition
3-37
To start and stop waveform acquisition
• To start waveform acquisition, click the start button at the bottom of
the waveform display area.
• To stop waveform acquisition, click the stop button at the bottom of
the waveform display area.
See figure 3-27.
You can still use the Run and Stop keys on the front panel while the graphical
interface is enabled. However, if you are performing many graphical interface
operations, it is easier to start and stop the oscilloscope using the buttons in the
interface, so you do not have to remove your hand from the mouse.
Figure 3-27
Start and Stop Icons
Click this button
to stop waveform
acquisition
Click this button
to start waveform
acquisition

Agilent Technologies 54831A Specifications

General

Brand	Agilent Technologies
Model	54831A
Category	Test Equipment
Language	English