495439_a 51
Settings
2. Activating/deactivating Eco mode:
■
Activate :
Activate Eco mode.
■
Deactivate :
Deactivate Eco mode.
7.4 Setting the rain sensor (Robolinho 450
W/700/1200/2000)
NOTE Mowing when the grass is dry re-
duces soiling. By activating the rain sensor and
setting a delay time, it is possible to prevent the
appliance mowing when the grass is wet.
If the rain sensor is activated, the appliance
moves back into the base station when the rain
begins. It remains there until the rain sensor has
dried. Then it waits for the time period that is set
as the delay before it continues mowing. The
sensitivity of the rain sensor is adjustable.
1. or * Rain sensor
2. Activating/deactivating the rain sensor:
■
or Activate :
Activate the rain sensor.
■
or Deactivate :
Deactivate the rain sensor.
3. Setting the delay of the rain sensor:
■
or * After rain delay
■
xx hours xx minutes
Select the required value for the delay
with or and accept with .
4. Setting the sensitivity of the rain sensor:
■
or * Rain sensitive
■
Select the required value for the sensitivi-
ty with or and accept with .
7.5 Setting the mowing program
7.5.1 Setting the mowing program – General
1. Call up the main menu with .
2. or * Programs
3. Select the menu item with or and ac-
cept with .
4. Carry out the settings.
Note:The menu items are described in the
following sections.
7.5.2 Setting the start points
Teaching-in start points
1. Place the appliance in the base station.
2. Switch on the appliance with .
3. Call up the main menu with .
4. or * Programs
5. or * Entry Point
6. or * Interactive teach
7. or * Start interactive entry
point teaching :
■
or Start . The appliance
moves along the boundary cable.
■
or Set when the appliance
has reached the required start point. The
start point is stored.
8. or Set entry point 1 if no
start point has been specified during the
teaching-in movement. If no start point has
been specified here, the start points are auto-
matically specified.
9. or Entry point x: XXm if
the last start point has been reached.
Manually specifying start points (05)
The first start point (05/X0) is pre-set and is 1m
to right of the base station. Other start points can
be defined after this point (see technical data).
When specifying the start points, heed the follow-
ing:
■
Do not set start points too far from the base
station or too close to one another(06/f).
■
Only use as many start points as necessary.
1. or * Entry Point
2. or * Point X1 at [020m]
Select one digit in sequence with or
and always accept with .
3. or * Point X2 at [075m]
Select one digit in sequence with or
and always accept with .
4. If necessary, specify further start points.
5. Return to the main menu with .
To Next Page
Loading...
Need help?
General
