GB
58 Robolinho
Help in case of malfunction
13.2 Fault codes and troubleshooting
NOTE For malfunctions that are not listed
in this table or that you cannot resolve yourself,
please contact our customer service.
Fault code Cause Remedy
CN001: Tilt sensor The inclination sensor has
been triggered:
■
Max. tilt exceeded
■
The appliance has been
carried
■
Slope too steep
Place the appliance on a flat surface
and acknowledge fault.
CN002: Lift sensor The lift sensor has triggered:
■
The appliance cover has
been deflected upwards
by lifting or by an obsta-
cle.
Remove the obstacle.
CN005: Bumper de-
flected
The appliance has driven in-
to an obstacle and cannot
free itself (e.g. collision close
to the base station).
■
Place the appliance on the free,
designated grass surface.
■
Correct the location of the boundary
cable.
CN007: No loop sig-
nal
■
No loop signal
■
The boundary cable is
faulty.
■
Loop signal is too weak.
■
Check the LEDs on the base sta-
tion.
■
Check the power source of the base
station. Disconnect and reconnect
the power supply.
■
Check the boundary cable for dam-
age. Repair the defective cable.
CN008: Loop signal
weak
■
Loop signal too weak
■
Boundary cable buried
too deep
■
Check the LEDs on the base sta-
tion.
■
Check the power source of the base
station. Disconnect and reconnect
the power supply.
■
Raise the boundary cable to the
prescribed height; attach directly on
the grass if necessary.
CN010: Bad position
■
The appliance is outside
the designated grass
surface.
■
The boundary cable has
been routed in a criss-
cross pattern.
■
Place the appliance on the free,
designated grass surface.
■
Correct the location of the boundary
cable around curves and obstacles.
Eliminate the criss-crossing of the
cable.
CN011: Escaped robot The appliance is outside the
designated grass surface.
Correct the location of the boundary ca-
ble around curves and obstacles.
To Next Page
Loading...
Need help?
General
