GB
52 Robolinho
Settings
7.5.3 Setting the mowing times
NOTE There must be at least 30min. be-
tween programming the mowing times and the
mowing start. If not, the appliance starts 30 min
after the last press of the button at the earliest.
In the Weekly Program menu item, the days of
the week and time periods when the appliance
should mow are set. Adapt these settings to the
size of your garden if necessary. If unmown ar-
eas are still visible after approx. one week, in-
crease the mowing periods.
1. or * Weekly Program
■
or * All Days [X]: The appli-
ance mows every day at the set times. If
All Days [] is shown, the appliance
only mows on the set days of the week.
■
or * Monday [X]...* Sunday
[X]: The appliance mows for the set
time periods on the set day of the week.
If Monday [] is shown, for example,
the appliance does not mow on the re-
spective day.
■
or Change : Activate the re-
spective day [X] or deactivate it [],
and set the time periods, type of mowing
and the start points.
2. Make the settings for every day or the re-
spective day:
■
e.g. *[M] 07:00-10:00 [?]: Normal
mowing [M] from 07:00 – 10:00am with
automatically changing start point 0 – 9
[?].
■
e.g. *[R] 16:00-18:00 [1]: The ap-
pliance starts with edge mowing [R] at 4
pmand moves along the entire boundary
cable. The area mowing then begins at
start point 1 [1]. At 6 pmor as soon as
the rechargeable battery is discharged,
the appliance moves back to the base
station.
■
or Change : Change the se-
lected setting.
■
or Continue : Confirm the
changes setting and continue to the next
setting.
3. or Save : Save all changed set-
tings of the menu item.
7.6 inTOUCH (Robolinho models "W")
An existing connection to a gateway can be dis-
connected. This means the appliance is ready to
establish a new connection for 30 minutes.
NOTE To establish a connection later, the
connection must first be disconnected again,
even if the appliance was not previously connect-
ed with a gateway.
1. or *inTOUCH
2. Reset connection
Appliance reports: Done.
3. Confirm with and return to the menu.
7.7 Edge mowing with a manual start
For a manual start, the setting can be made here
that the appliance begins with edge mowing.
Carrying out the edge mowing at the pro-
grammed mowing time periods: see chapter 7.5.3
"Setting the mowing times", page52.
1. or * Margin mowing
2. or * at manual start
7.8 Setting the secondary area mowing
1. or * Sub zone mowing
2. Setting the mowing time periods:
■
or inactive :
Secondary area mowing is switched off.
■
or active :
The appliance mows until the recharge-
able battery is flat.
■
or Mowing time in min :
The appliance mows the secondary area
for the set time period. The following
mowing time periods can be set:
30/60/90/120/until rechargeable battery
flat.
7.9 Setting the display contrast
If the display is difficult to read, e.g. in sunlight,
the display can be improved by changing the dis-
play contrast.
1. or * Display contrast
2. Increase/decrease the display contrast with
or and accept with .
To Next Page
Loading...
Need help?
General
