OmniSwitch 6850 Series Chassis and Hardware Components OmniSwitch 6850 Series Power Supplies
OmniSwitch 6850 Series Hardware Users Guide August 2007 page 2-81
3 Carefully slide the power supply against the back of the chassis until the power connector connect.
4 If you have installed the power shelf tighten the captive screws (or screws) located at back of the
power supply to the power shelf.
Connecting a Power Supply with a Cable
The following sections describe how to rack-mount a power supply shelf and connect the power supply
with a cable.
Power Supply Shelf Rack Mounting Steps
Follow the steps below to rack-mount the power supply shelf:
1 Align the threaded holes in the provided rack-mount flanges with the two holes in the power supply
shelf. These holes are located on the left and right sides of the shelf.
2 Attach the flanges to the chassis using the provided Phillips-head screws. The screws slide through the
non-threaded holes from the inside of the power supply shelf and are then attached to the mounting brack-
ets using the threaded holes. Be sure to tighten each of the screws firmly using a Phillips screwdriver.
Attaching a Rack-Mount Flange
To Next Page
Loading...
Need help?
General
