Managing OmniSwitch 6850 Series Stacks Monitoring the Stack
OmniSwitch 6850 Series Hardware Users Guide August 2007 page 4-37
Monitoring the Stack
As shown in the previous sections, monitoring the current status and operation of all elements in a stack
can help users avoid unexpected stack conditions. The table below includes CLI commands that are useful
in monitoring stack conditions.
Visually Monitoring the Stack
Users can also monitor many stack operations by viewing the front panel LEDs on all elements in the
stack. Refer to “Status LEDs” on page 2-54 for detailed information on LEDs and stack status.
CLI Commands Used for Monitoring a Stack
show stack topology Displays the current operating topology of switches within a stack.
show stack status Displays the current redundant stacking cable status and token
availability for a stacked configuration.
show running-directory Displays the directory from where the switch was booted. This com-
mand also shows important information, including whether the soft-
ware across the stack is synchronized.
show chassis Displays basic configuration and status information for the switch
chassis.
show cmm Displays basic hardware and status information for primary and
secondary management modules operating in the stack.
show ni Displays basic hardware and status information for modules currently
operating in the stack.
show module Displays basic information for modules installed in the stack. Modules
include primary and secondary management modules and any modules
operating in idle status.
show module long Displays detailed information for modules installed in the stack. Mod-
ules include primary and secondary management modules and any
modules operating in idle status.
show module status Displays basic status information for modules installed in the stack.
Modules include primary and secondary management modules and any
modules operating in idle status.
show power Displays hardware information and current status for chassis power
supplies. This includes the status of backup power supplies, if applica-
ble.
show fan Displays the current operating status of each of the six fans operating in
each chassis.
show temperature Displays the current operating chassis ambient temperature, as well as
current temperature threshold settings for each of the modules in the
stack.
To Next Page
Loading...
Need help?
General
