82 Rockwell Automation Publication 1756-UM013B-EN-P - October 2019
Chapter 5 Configure and Replace Safety Modules
Edit the Module
Configuration Common
Categories
You click the category names in the New Module dialog box to view and change
the configuration parameters. Before you edit the module configuration,
consider the following:
• This chapter shows how to edit the module configuration when you add
the module to the Logix Designer application project.
If you access the module configuration after it is added to the project, the
dialog box is named Module Properties. The same categories are displayed
as the categories displayed on the New Module dialog box.
• Some new module configuration categories apply to all 1756
ControlLogix digital safety I/O modules. Some categories are specific to
the module type.
The following categories apply to all 1756 ControlLogix digital safety I/O
modules and are described in this section.
• General Category
• Connection Category
• Safety Category
• Module Info Category
IMPORTANT By default, all safety input and output channels on 1756 ControlLogix digital
safety I/O modules are disabled.
You must configure each point that is used in a Safety application.
To Next Page
Loading...
Need help?
General
