42 Rockwell Automation Publication 2100-IN012G-EN-P - August 2016
Chapter 2 Installation Procedures
Bus Torque Specifications
Tighten all bus splice connections with a torque wrench and socket at intervals
established by your maintenance policy. See Chapter 9
for suggested
maintenance. If a torque wrench is not available, tighten until the conical
spring washer is flat.
Torque values can be found on the information label on the interior of the
vertical wireway door or on the interior right-hand side plate of frame mounted
units.
To Next Page
Loading...
Need help?
General
