Rockwell Automation Publication 520-UM001G-EN-E - September 2014 3
Summary of Changes
This manual contains new and updated information.
New and Updated
Information
This table contains the changes made to this revision.
Topic Page
Added Warning table for Motor Cable Length Restrictions 32
Updated Maximum Control Wire Recommendations information on noise immunity 36
Updated Start Method and Stop Method tables for PowerFlex 523 drives 37
Updated Start Method and Stop Method tables for PowerFlex 525 drives 40
Added Important table for EMC category C3 installation information 52
Updated Additional Installation Requirements table for meeting EMC 53
Updated Recommended Placement of EMC Cores table 54
Added software version requirement for Automatic Device Configuration (ADC) support 60
Added new parameter d392 [RdyBit Mode Act] 67, 106, 142
Added new parameter A574 [RdyBit Mode Cfg] 67, 129, 142
Updated descriptions of options for parameter P040 [Autotune] 78
Updated description of PointStop for option 10 and 11 of parameter P045 [Stop Mode] 79
Added Important table to parameter P046, P048, P050 [Start Source x] 80
Updated entries for Maximum Output column of parameter t088 [Analog Out Sel] from
“200% Drive Rated FLA” to “200% Drive Rated Current”
89
Added table of recommended minimum Encoder PPR to parameter A536 [Encoder PPR] 122
Updated Intermittent Overload specification for PowerFlex 523 158
Added catalog numbers for replacement EMC cores 170
Updated I/O Terminals C1 and C2 wiring information on noise immunity 190
Added recommended Ethernet cables to description of Appendix H 235
General maintenance updates Throughout manual
To Next Page
Loading...
Need help?
General
