Rockwell Automation Publication 750-IN100B-EN-P - July 2017 19
Chapter 2
Receiving, Handling, and Storage
PowerFlex 755T product enclosures are bolted to wooden skids for shipment.
For ease of handling, Rockwell Automation recommends leaving the
enclosures bolted to the skids until moved to the final installation area. The
enclosures must remain in an upright position during handling.
Receiving
Standard packaged PowerFlex 755T product enclosures are shipped upright as
a whole unit or in shipping sections as required. See page 20
for details on
shipment configurations. Each unit or shipping section is bolted to a shipping
skid with removable shipping cleats and is covered with clear plastic wrap.
Protection is for upright shipping and is not waterproof or watertight.
Heavy duty/export packaging is similar to standard packaging, but uses a poly
wrap suitable for occasional light water-spray. In addition, wood framing and
sheeting surround the unit or shipping section. Heavy duty/export packaging
is not waterproof, watertight, or intended for long-term storage.
Upon delivery of the PowerFlex 755T product, refer to the packing slip for
sizes and exact shipping weights. The packing slip will also list the items that
are included in the shipment.
Inspect the shipment for damaged or lost items. If the packaging appears to be
damaged, unpack the equipment for further inspection. Open the doors and
inspect the major components for signs of damage. PowerFlex 755T enclosures
utilize a key-operated door latch. A double-bit door key is taped to the
enclosure door.
ATTENTION: To avoid personal injury or structural damage, never attempt to
lift or move the product by any means other than the handling methods
outlined in this publication. PowerFlex 755T products are top- and front-
heavy.
ATTENTION: Exercise caution when moving the product to ensure the
equipment is not scratched, dented, or damaged in any manner. Stabilize the
product during handling to prevent tipping and injury to personnel.