Rockwell Automation Publication 20C-PM001F-EN-P - March 2012 103
Appendix C
History of Changes
Changes to This Manual
This appendix briefly summarizes changes that have been made with revisions of
this manual. Reference this appendix if you need information to determine what
changes have been made across multiple revisions. This may be especially useful if
you are deciding to upgrade your hardware or software based on information
added with previous revisions of this manual.
The information below summarizes the changes to the PowerFlex 700H
Adjustable Frequency AC Drive Programming Manual, publication 20C-
PM001, since the May 2008 release.
Change
Added a reference to the PowerFlex 700S/700H Open Power Structure, Frames 10…14 Installation Instructions,
publication PFLEX-IN020.
Added an icon for 32 bit parameters to the “About Parameters” explanation section and each applicable parameter
description.
The default value of the following parameters has been changed to “Based on Drive Rating”:
41 [Motor NP Volts] 63 [Flux Current Ref] 107 [Preset Speed 7]
42 [Motor NP FLA] 69 [Start /Acc Boost] 119 [Trim Hi]
43 [Motor NP Hertz] 71 [Break Voltage] 148 [Current Lmt Val]
44 [Motor NP RPM] 72 [Break Frequency] 158 [DC Brake Level]
45 [Motor NP Power] 84 [Maximum Speed] 160 [Bus Reg Ki]
46 [Mtr NP Pwr Units] 91 [Speed Ref A Hi] 164 [Bus Reg Kp]
55 [Maximum Freq] 94 [Speed Ref B Hi]
62 [IR Voltage Drop 97 [TB Man Ref Hi]
Added options 18…20 “DPI Port 1…3” to parameter 96 [TB Man Ref Sel].
Updated Par 145 [DB While Stopped] description to indicate use with frame 9 drives only.
Updated the F10 “System Fault” fault description to include removal of the 20C-DG1 option board.
Updated the list of possible digital input conflicts for fault 135 “DigIn CnflctC”
Add subcode 2080 (for Fault 10).
Add subcode 528 (for Fault 104).
To Next Page
Loading...
Need help?
General
