Rockwell Automation Publication 20C-PM001F-EN-P - March 2012 11
Chapter 1
Drive Start-Up
This chapter describes how you start up the PowerFlex 700H drive. Refer to
Appendix
A for a brief description of the LCD Human Interface Module (HIM).
Prepare For Drive Start-Up
Before Applying Power to the Drive
❏ 1. Confirm that all inputs are connected to the correct terminals and are
secure.
❏ 2. Verify that AC line power at the disconnect device is within the rated value
of the drive.
❏ 3. Verify that control power voltage is correct.
The remainder of this procedure requires that a HIM be installed. If an
operator interface is not available, remote devices should be used to start
up the drive.
For Information on… See page…
Prepare For Drive Start-Up Below
Start-Up the Drive 12
ATTENTION: Power must be applied to the drive to perform the following start-
up procedure. Some of the voltages present are at incoming line potential. To
avoid electric shock hazard or damage to equipment, only qualified service
personnel should perform the following procedure. Thoroughly read and
understand the procedure before beginning. If an event does not occur while
performing this procedure, Do Not Proceed. Remove Power including user
supplied control voltages. User supplied voltages may exist even when main AC
power is not applied to then drive. Correct the malfunction before continuing.
To Next Page
Loading...
Need help?
General
