ASSEMBLY/DISASSEMBLY
Vector™ H Serie s ▪ S ervice M an ual ▪ MN-4 6 543 ▪ R ev 01 ▪ 11/ 1 9
98
Continued from previous page
3. Remove the mounting screws and remove the motor support plate.
4. Cut the insulation around the motor.
Remove the three mounting screws and remove the motor and blower
wheel from the housing.
Install the new motor with the three mounting screws. Tape all the seams
in the insulation.
5. Re-connect the motor wire connectors.
6. Re-install the motor support plate.
Re-install the top and right side service panels.
Connect electric power to the appliance and test all functions.
Result The blower motor has been replaced.
VMC-TS-002942
VMC-TS-002945
To Next Page
Loading...
Need help?
General
