AMX SC-N8012 User Manual

Chapter 3: Configuration Options
21
N-Command User Manual
Script Builder Page
Click Build > Script Builder to access the page shown in Figure 17. Scripts are programs you write to use over and over again. For
example, you could create scripts that shut all equipment down for the evening, putting your Encoders and Decoders in lower
power mode, turning off all TVs and lights, etc. A predefined set of commands could be created here. Basically, anything that can be
controlled with TCP commands can be controlled in this script. There are also predefined actions that you can choose (no
programming knowledge needed). Options are described in Ta bl e 11
.
NOTE: Script commands are accessible via TCP port 50020 and SSL port 50120.
FIG. 17
Script Builder Page
TABLE 11 Script Builder Option Descriptions
Option Description Notes
Script selection drop-
down
Select an existing script to load. This list shows all
scripts that were already created and saved on this unit.
Scripts are displayed in the format:
"Script ID":"Name of script"
Load button Click to load the script selected from the drop-down
(described previously).
Delete button Click to delete the selected script.

AMX SC-N8012 Specifications

General

Brand	AMX
Model	SC-N8012
Category	Controller
Language	English

Summary

IMPORTANT SAFETY INSTRUCTIONS

Chapter 1: Introducing Your New N8000

Product Overview

Overview of N-Command Series features and specifications for N8001, N8002, N8012.

Hardware Overview

Details the front and rear panel hardware for N8001, N8002, and N8012 controllers.

Chapter 2: Installing and Configuring the N8000

Connecting the N8000 to the Network

Guide for physically connecting the N8000 controller to the network.

Establishing Communication with the N8000

Configuring IP addresses and establishing web browser communication.

Logging In

Process for accessing the N-Command web interface using default credentials.

Chapter 3: Configuration Options

Local Play Options

Options for managing local playback features, including playlists and uploads.

Backups Options

Options for creating and restoring system backups and migrating unit settings.

Appendix A: Panel Builder Tutorial

Beginning a Panel Builder Project

Step-by-step guide to starting a new project in Panel Builder.

Appendix C: Minimum Network Requirements

Managed Network Switch

IGMP Snooping and Querying

Appendix D: N-Command Failover Configuration

Failover Scenarios and Triggers

Master/Slave Setup and Configuration

Stopping Master/Slave Relationship